Base Mesh Continued, Feet, head ect.

 For this week I continued modelling the base mesh for my Wyvern character, Ripsnarl. There isn't much to say here, I used the variety of skills and knowledge I had learned up untill this point for this week, without really requiring looking anything else up.

I started working on the head first, modelling the lower jaw and upper jaw/head as seperate objects first. I moved the pivot on the lower-jaw to the middle so that the jaw could rotate open and close somewhat realistically. I used a lot of references of Cobra's for this head as that is what Ripsnarls head is directly based upon. Later I merged the upper jaw/skull to the neck so I could model the cobra hood more intricatley. I was still focused on shapes though rather than high detail.

Next I created the feet of the charcter, I first started attempting this with Zspheres however it was very difficult to do in this manner, so instead I used a cube to create and carve a foot into, using symmetry and then duplicated and welded the foot so it would be the same on the other foot. Then I moved onto the nails of the feet, using one modelled nail and duplicating/resizing it for the other's on each toe. For the wing nails I also used the nails from the feet, modified and altered a little so they didn't look identicle.

I made two teeth, one for the upper jaw's fangs, and one for the lowerjaws teeth. These were then duplicated and resized as required to add interest and a level of difference, before being merged with their respective meshes. 

I used snakehooks to make the fin ridges along the tail, and manipulated and resized them.